When we arrive at your doorstep, our team will give you a courtesy call and inform you of our arrival. We will then inspect the vehicle, assess the required work scope, and locate the power and water source at your home. Afterward, we’ll quickly set up our equipment, which takes about 5 minutes.

Before starting the Engine Bay detail, we take several safety precautions such as covering the intake if exposed, alternator and battery terminals. We also make sure the engine is cold so that the products do not dry on sensitive surfaces. Once completed, we start by removing all the loose debris and contaminants on the surface or crevices by air compression and low pressure washing. We then apply degreasers and specialised cleaners that will not damage rubber and plastics and kickstart the agitation process with a soft bristle brush. Tight crevices will be steam cleaned to ensure we reach all areas. Once we are satisfied with the results of the agitation process we will rinse down all the cleaners with low pressure. We then use air compression to push out all the water from all the tough to reach areas and apply UV protectants to keep the rubber and trims from fading or cracking.

Once your vehicle is fully cleaned, we conduct a final inspection to ensure consistent quality. We will then notify your designated contact person that the job is complete. After a thorough walkthrough of the car, we will hand over the keys and your belongings to you.